Thermal Extraction Devices

Loading search index…

    Thermal engineering & extraction device archive

    Storz & Bickel Mighty+ (TED-0003)

    Technical Specifications

    Property Specification
    Manufacturer Storz & Bickel GmbH
    Part Number 01 01 MY (Storz & Bickel article number, MIGHTY+ product page) [^3]
    Form Factor Handheld portable vaporizer with a fixed cooling-unit mouthpiece (direct-draw); not a desktop unit [^3]
    Release Year 2021 [^1]
    Heating Method Hybrid conduction and convection: Storz & Bickel states all of its devices use “a patented combination of hot air convection and additional conduction heating,” with the Filling Chamber itself heated in addition to the pre-heated air stream [^8]
    Heat Generation Electric resistance heater inside the ceramic-coated aluminum Filling Chamber; the manufacturer does not publish the specific element sub-type (rod, coil, or cartridge), so the general resistive value is used here rather than a more specific one [^3][^8]
    Operation Mode Session
    Temperature Range 40 °C – 210 °C (104 °F – 410 °F), adjustable [^2]
    Temperature Control Digital OLED display (set-point control)
    Chamber Volume 1.4 cm³ (per manufacturer); ≈0.25 g raw flower is a third-party estimate, not an official figure [^3]
    Chamber Surface Ceramic-coated aluminum
    Cooling Unit / Airpath PEEK cooling unit with a labyrinth-designed airpath (per manufacturer) [^4]
    Power Source Two internal lithium-ion cells, 3300 mAh total (per manufacturer); “18650” cell format is reported by third parties, not stated officially [^5]
    Charging USB-C with Power Delivery (5–15 V), max. power consumption ≈45 W; complies with IEC 60335 and EN 55011 (consumer electrical safety and EMC; distinct from the medical-device certification below); “Supercharge” reaches ≈80 % in ≈40 minutes; rated operating temperature 5 °C–35 °C (41 °F–95 °F) [^5]. Pass-through operation is supported with a sufficiently powerful USB-C supply (≥15 V @ 3 A): the batteries are bridged and the display shows “dct” to confirm pass-through charging, but the unit does not run directly on mains power without its batteries fitted — this archive does not tag mains alongside battery for that reason [^5]
    Heat-Up Time ≈60–70 seconds to 180 °C (per manufacturer) [^2]
    Compatible Media Dry botanical flower; concentrates via stainless steel pad

    Medical Device Status & Certification

    Safety Notes

    • Official pre-use guidance: confirm vapors from cleaning agents or disinfectants have fully evaporated before turning the device on; do not block or cover the air vents during use or cooling down; inspect the vaporizer and power supply for visible damage before use; confirm the voltage on the rating plate matches the local power supply; fully charge the device before first use; do not leave it unattended during operation, and unplug the power adapter immediately if a malfunction occurs 1.
    • The device carries two internal lithium-ion cells (3300 mAh total); allow it to cool completely before storage, and use only the original Storz & Bickel charger to avoid damage or voiding the warranty 21.
    • See also “Medical Device Status & Certification” below for the consumer-vs-medical certification distinction.

    Cleaning & Maintenance Protocol

    1. Disassembly: Separate cooling unit top piece, mouth piece, screen, and sealing rings.
    2. Soaking: Submerge non-electronic cooling unit components in >90% isopropyl alcohol for up to 30 minutes.
    3. Reassembly: Rinse thoroughly with clean warm water, air dry completely, and inspect silicone o-rings prior to operation.

    Accessories & Consumables

    • Stainless Steel Dosing Capsules
    • Replacement PEEK Cooling Units
    • Wear & Tear Screen Sets

    Manufacturer Connection

    Sources

    1. Storz & Bickel support, “Operation” (MIGHTY+ safety instructions before use, charging, automatic shutdown). Snapshot 2026-08-08. https://support.storz-bickel.com/hc/en-us/articles/36165025129233-Operation ↩ ↩2

    2. Storz & Bickel support, “Technical Overview” (2 Li-ion batteries, 3300 mAh total; USB-C; USB-C PD 5–15 V; max. power consumption 45 W; operating temperature 5 °C–35 °C; compliance IEC 60335, EN 55011; pass-through/“dct” charging behavior). Snapshot 2026-08-08; corrects a stale URL previously cited in this record. https://support.storz-bickel.com/hc/en-us/articles/36136284925585-Technical-Overview ↩

    Derived navigation generated from structured relationships. Links are labeled by edge class and evidence trace; derived links are navigation, not primary assertions.

    Related (2)